FREE CANADIAN SHIPPING on all orders over $95* Processing times within a few hours!
FREE CANADIAN SHIPPING on all orders over $95* Processing times within a few hours!
TO-MSK-250
As you can tell from the name, the MSK-200 Stainless Steel Shaft with EzyLock is made of stainless steel for maximum service life. With the Tormek EzyLock, which works as both a nut and a washer, it's easy to mount the grinding wheel with nothing but your bare hands. The large pitch of the left-hand washer nut causes the rotational force of the grinding wheel to tighten the nut.
If you need to replace your grinding wheel, turn it clockwise while holding the honing wheel with your other hand. The EzyLock nut will then automatically release. This design makes it easy to work with different grinding wheels. When mounting the grinding wheel, turn the EzyLock nut counterclockwise by hand. When you start sharpening, the nut will automatically be tightened to the correct torque.
The newer drive wheels manufactured from 1993 onwards have a deep groove for the drive pin. You use the pre-drilled hole on these.
Older drive wheels manufactured before 1993 have a shallower groove for the drive pin. If you have one of these, you can either buy a new drive wheel (art. no. R23) or drill a hole 4 mm (0.16") in diameter. More information can be found in the Instructions MSK-250 EN document.
They fit the Tormek T-8, Tormek T-7, Tormek 2000 and older models with a 250 mm (9 7/8") diameter grinding wheel.
Shipping weight 0.48 kg (1.06 lb)
Silver
Stainless steel
2-year warranty
See how easy it is to change grinding wheels with EzyLock, included in the MSK-250 Stainless Steel Shaft with EzyLock.
Watch this special episode of the Tormek Live Sharpening Classes and see which machine models you can upgrade with the MSK-250 Stainless Steel Shaft with EzyLock.
The MSK-250 Stainless Steel Shaft with EzyLock comes fully assembled and ready to install.
